Home / Siemens NX / Make Corner siemens NX

Make Corner siemens NX

Use the Make Corner command to create a corner by extending and/or trimming two input curves to a common intersection. If the Create Inferred Constraints option is on, a coincident constraint is created at the intersection.

sk_make_corner_ov

Make Corner works with:

  • Lines

  • Arcs

  • Open conics

  • Open splines (trimming only)

You can also hold the left mouse button and drag over curves create a corner.

Where do I find it?

Toolbar

(Modeling) Direct SketchMake Corner make_corner

(Drafting and Sketch task environment) Sketch ToolsMake Corner make_corner

Menu

(Modeling and Drafting) EditSketch CurveMake Corner

(Sketch task environment) EditCurveMake Corner

Leave a Reply

Your email address will not be published. Required fields are marked *