Home / Siemens NX / Pinch Turning tips siemens NX

Pinch Turning tips siemens NX

  • pinch_turn_complete_anim
  • Remember that when you use Pinch Turning the cutting moves are synchronized since they are the same and have a controlled feedrate.

  • Make sure that you have the non cutting moves synchronized too.

  • Since both turrets might have different acceleration/deceleration parameters it’s not simply syncing the start of the first cut. To make sure you have a correct synchronized path you need a sync point at the start of every cutting move.

  • Another option is to give the non cutting moves a given feedrate.

  • Both cases assume that the feedrate accelerations/deceleration parameters are similar.

Leave a Reply

Your email address will not be published. Required fields are marked *