Home / Siemens NX (page 32)

Siemens NX

Fit Spline siemens NX

Use the Fit Spline command to create a spline by fitting it to specified data points. Where do I find it? Toolbar (Sketch task environment) Sketch Tools→Fit Spline Menu (Sketch task environment) Insert→Curve→Fit Spline (Drafting) Insert→Sketch Curve→Fit Spline

Read More »

Studio Spline siemens NX

Use the Studio Spline command to dynamically create splines using either points or poles. The functionality is the same as the Modeling Studio Spline, with the following exceptions: There is no Associative option. The default number of degrees is 3. Studio Splines Using Through Points and By Poles Where do …

Read More »

Polygon siemens NX

Use the Polygon command to create polygons by specifying: Center point Number of sides Radius Rotation angle Polygons can be created using the following methods: Inscribed Radius Circumscribed Radius Side of Polygon For this example, the following values are used: Number of Sides = 8 Size = Inscribed Radius Radius …

Read More »

Rectangle siemens NX

Use the Rectangle command to create a rectangle using one of three methods: By 2 Points Creates a rectangle from 2 points in diagonal corners. The rectangle is parallel to the XC and YC sketch axes. By 3 Points Creates a rectangle from a start point and two points that …

Read More »

Chamfer siemens NX

Use the Chamfer command to bevel a sharp corner between two sketch lines. You can create the following chamfer types: Symmetric Asymmetric Offset and Angle You can also hold the left mouse button and drag over curves to create a chamfer. Where do I find it? Toolbar (Modeling) Direct Sketch→Chamfer …

Read More »

Fillet siemens NX

Use the Fillet command to create a fillet between two or three curves. You can: Trim all input curves or leave them untrimmed. Delete the third curve of a three-curve fillet. Specify a value for the fillet radius, or preview the fillet and determine its size and location by moving …

Read More »

Circle siemens NX

Use the Circle command to create circles with one of two methods: A center point and a diameter Two points on the circle, and a diameter This example shows the center point and diameter method. You can use either coordinate values or parameters for both methods. While you are rubberbanding …

Read More »

Arc siemens NX

Use the Arc command to create an arc with either of two methods: Specify the arc start and end points, and the radius. Specify the arc center and the start and end points. This example shows the arc start/end points and radius method. Where do I find it? Toolbar (Modeling) …

Read More »

Derived Lines siemens NX

Use the Derived Lines command to create new lines from existing lines. You can create any of the following: Any number of offset lines from a base line. A line midway between parallel lines. A bisector line between non-parallel lines. Where do I find it? Toolbar (Modeling) Direct Sketch→Derived Lines …

Read More »

Line siemens NX

Use the Line command to create lines with constraint inferencing. This example shows the first line point at XC-YC 90 and 70 (1) , and the second line point at length 45 and angle 300 degrees .(2) Where do I find it? Toolbar (Modeling) Direct Sketch→Line (Drafting and Sketch task environment) …

Read More »